Metabo Welding Machine MIG/MAG 160 Specifikace stáhnout pdf (Strana 13)

13

ENGLISH

3.4 MIG/MAG 200/40 XT,

MIG/MAG 250/60 XT,

MIG/MAG 300/45 XT

The welding machine is equipped with a

wheel set. This provides for convenient

relocation of the welding machine com-

plete with gas cylinder to the job site.

A

Danger!

• Close the cylinder's valve before

moving the machine.

• Bear in mind the welding

machine's heavy weight. Espe-

cially on sloping ground one can

quickly loose control over the

machine!

Walk along the intended way,

before setting out with the weld-

ing machine.

If necessary, let a second person

assist you!

• When on site, secure machine

against rolling away.

4.1 Hoisting by Crane

The welding machine may be hoisted by

crane.

A

Danger!

• Remove the gas cylinder from the

machine before hoisting.

Crane hoisting with a gas cylin-

der on the machine is prohibited!

• Hoisting at the handle is not per-

missible.

• Position hoisting slings as illus-

trated.

1. Connect earth cable to the earth

cable connector.

2. Connect welding gun to the Euro

connector.

19 Earth cable connector (cable

socket 50)

20 Main switch

Position I: Machine turned ON,

if supply voltage of 230V or

400V is selected with the sup-

ply voltage selector switch(22).

Position II: Machine turned

OFF, earthed outlet opera-

tional.

21 Earthed outlet

Works only with neutral wire in

mains supply line and machine

turned OFF.

22 Supply voltage selector

switch

230V – 0 (machine OFF) –

400V.

23 Welding step selector switch

Switches the welding current

(voltage) in six steps.

24 Connector for welding gun

Accepts all commercially avail-

able welding guns (Euro con-

nector KZ-2).

25 Earth cable connector (cable

socket 50)

26 Main switch

Position I: Machine turned ON

Position II: machine turn OFF,

earthed outlet operational

27 Earthed outlet

Works only with neutral wire in

mains supply line and machine

turned OFF.

25

24

26

27

28

29

28 Welding current fine setting

selector switch

Switches the welding current

(voltage) in six steps.

29 Welding current coarse set-

ting selector switch

Switches the welding current

(voltage) in two steps.

30 Backburn time potentiometer

Knob turned fully to the

left = minimum backburn time

31 Chain holder

Chain secures gas cylinder on

machine

32 Shielding gas line

33 Power supply cable

4. Transport

30

31

32

33

5. Preparing for Operation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Komentáře k této Příručce

Žádné komentáře